Step 1 - Connect the HandyTone 486 to your network
- Plug the cord(s) of your analogue telephone(s) on the RJ-11 FXS
port at the back side of your HT486.
- Plug a UTP Ethernet cable connected to your network (Hub, Switch
or Router) on RJ-45 Ethernet port at the back side of your HT486.
- Plug the power supply of your HT486 on the power port at the back
side of your device and then on a power socket.
* If you have received a pre-configured device directly from VoIP,
go to step 4.
Step 2 - Verify the IP address of your ATA
The HandyTone 486 is coming standard configured with its DHCP client
enabled. A DHCP sever required in your network in order to provide
it with an IP address.
- Pickup the phone connected on FXS port
- Then press the red-light button on the top
- Listen the voice configuration menu and
- Dial 02 when you are prompted to "enter menu"
- Listen the IP address of your HT486
Step 3 - Use a browser to login and configure your ATA
- Open a web browser to the address: http://<IPADDRESS>/admin,
where <IPADDRESS>is the IP address of your HT486 (found previously
during the pre-configuration step 2).
- Enter the default password: Admin in order to access the next,
main configuration page.
On the displayed web page set the following:
Set SIP Server to: sipX.VoIPVoIP.com
Set SIP User ID to: your VoIP account (Call number): 555xxxxxxx
Set Authenticate ID to: your VoIP account (Call number): 555xxxxxxx
Set Authenticate Password to: your VoIP account password
Set Name to: <YOUR name>(visible to the others when you call)
Set (or confirm) SIP Registration to: Yes
Set Register Expiration to: 15
Set (or confirm) SIP Registration to: Yes
Set (or confirm) NAT Traversal to: No
Press the Update button at the bottom of the web page, and in the
following page,
Click on link: "Click to view your changes" to go back
in the configuration page, and
Press the Reboot button at the bottom of the web page
Step 4 - Start using your ATA
Pick up the phone, hear the dial tone, and start dialling:
|
